AutomaticPresignalBlocks - Revision history

Orudge: Reformat and update

2011-06-18T15:32:55Z

Reformat and update

@@ Line 1: / Line 1: @@
 With automatic pre-signal setups enabled (see [[Presignals| Pre-signals]]), all signal blocks that satisfy the following conditions will be converted to pre-signal blocks:
 #At least one one-way signal going in
@@ Line 11: / Line 5: @@
 If these three conditions are met, the one-way signals from condition 1 will be turned into a pre-signal, and the two-way signal(s) satisfying condition 3 will be turned into pre-signal exits. All other signals are left as they are, in particular, non-conforming two-way signals will not be converted.

Pm-bot: Bot: Automated text replacement (--= +==)

2011-06-15T11:26:04Z

Bot: Automated text replacement (--= +==)

← Older revision		Revision as of 11:26, 15 June 2011
Line 1:		Line 1:

	'''''How to set up automatic pre-signal blocks'''''

	=Automatic pre-signal blocks=		=Automatic pre-signal blocks=
Line 6:		Line 5:
	How to set up automatic pre-signal blocks		How to set up automatic pre-signal blocks

	With automatic pre-signal setups enabled (see [[Presignals\|Pre-signals]]), all signal blocks that satisfy the following conditions will be converted to pre-signal blocks:		With automatic pre-signal setups enabled (see [[Presignals\| Pre-signals]]), all signal blocks that satisfy the following conditions will be converted to pre-signal blocks:
	#At least one one-way signal going in		#At least one one-way signal going in
	#At least two two-way signals		#At least two two-way signals
	#At least one of these two-way signals leads to a block with another one-way signal going out, or an end-of-line.		#At least one of these two-way signals leads to a block with another one-way signal going out, or an end-of-line.

	If these three conditions are met, the one-way signals from condition 1 will be turned into a pre-signal, and the two-way signal(s) satisfying condition 3 will be turned into pre-signal exits. ~~ ~~All other signals are left as they are, in particular, non-conforming two-way signals will not be converted.		If these three conditions are met, the one-way signals from condition 1 will be turned into a pre-signal, and the two-way signal(s) satisfying condition 3 will be turned into pre-signal exits. All other signals are left as they are, in particular, non-conforming two-way signals will not be converted.

Orudge: 1 revision

2011-06-12T19:02:48Z

1 revision

New page

'''''How to set up automatic pre-signal blocks'''''

=Automatic pre-signal blocks=

How to set up automatic pre-signal blocks

With automatic pre-signal setups enabled (see [[Presignals|Pre-signals]]), all signal blocks that satisfy the following conditions will be converted to pre-signal blocks:
#At least one one-way signal going in
#At least two two-way signals
#At least one of these two-way signals leads to a block with another one-way signal going out, or an end-of-line.

If these three conditions are met, the one-way signals from condition 1 will be turned into a pre-signal, and the two-way signal(s) satisfying condition 3 will be turned into pre-signal exits.  All other signals are left as they are, in particular, non-conforming two-way signals will not be converted.